BLE MMS Demo
Device Response Console
Disconnected
Open
Close
Clear
Auto Start
EMV
NFC
MSR
Touch
Command Data
Send Command
DynaFlex: START EMV ALL
DynaFlex: START EMV MSR ONLY
DynaFlex: START EMV CONTACT ONLY
DynaFlex: START EMV CONTACTLESS ONLY
DynaProx: START EMV CONTACTLESS ONLY
DynaFlex: CANCEL Transaction
DynaFlex: START EMV ALL + BARCODE ENABLED
DynaFlex: START EMV MSR + BARCODE ENABLED
DynaFlex: START EMV CONTACT + BARCODE ENABLED
DynaFlex: START EMV CONTACTLESS + BARCODE ENABLED
DynaProx: START EMV CONTACTLESS + BARCODE ENABLED
DynaFlex: CANCEL Transaction
DynaFlex: START EMV ALL + BARCODE DISABLED
DynaFlex: START EMV MSR + BARCODE DISABLED
DynaFlex: START EMV CONTACT + BARCODE DISABLED
DynaFlex: START EMV CONTACTLESS + BARCODE DISABLED
DynaProx: START EMV CONTACTLESS + BARCODE DISABLED
DynaFlex: CANCEL Transaction
Display Amount at Prompt
Display Tax/Tip Options % Amount + Custom
Display Tax/Tip Options $ Amount + Custom
Request PIN with Host Data
PIN Entry Success (Send this Response AFTER Request PIN)
PIN Entry Fail (Send this Response AFTER Request PIN)
Request PIN with Card Read ALL PBF0
Request PIN with Card Read MSR Only PBF0
Request PIN with Card Read Contact Only PBF0
Request PIN with Card Read Contactless Only PBF0
PIN Entry With Card Read Success (Send this Response AFTER Request PIN)
PIN Entry With Card Read Fail (Send this Response AFTER Request PIN)
Manual PAN Entry
Request Signature
Get Rotation Status
Set Rotation 00 MSR top
Set Rotation 01 MSR right
Set Rotation 02 MSR left
Set Rotation 03 MSR bottom
Reset Device
Display Amount
Display Amount OK?
Display Approved
Display Welcome
Display Screen 1
Display Screen 2
Display Screen 3
Display Screen 4
Get Device SN
Get Device Capabilities
Get Device Firmware Version
User Selection: 00
User Selection: 01
NFC (1031)
NFC Mifare (1041)
NFC Mifare2 (1051)
Get User Notify Status
Set DynaFlex: User Notify to All Events, AND Barcode (9F)
Set DynaFlex: User Notify to All Events, NO Barcode (1F)
Set DynaProx: User Notify to Contactless Events AND Barcode (83)
Set DynaProx: User Notify to Contactless Events NO Barcode (03)
Set DISABLE User Notify Events (00)
Reset Device
Set USB to HID
Set USB to IAP
Set USB to Auto IAP
Single Beep Positive Tone (500ms)
Single Beep Positive Tone (250ms)
Single Beep Negative Tone (500ms)
Single Beep Negative Tone (500ms)
Double Beep Positive Tone (500ms)
Double Beep Positive Tone (250ms)
Double Beep Negative Tone (500ms)
Double Beep Negative Tone (250ms)
Two Tone Alert Version 1
Two Tone Alert Version 2
Four Tone Alert Version 1
Four Tone Alert Version 2
Four Tone Ascending Chromatic Alert
Four Tone Descending Chromatic Alert
Five Tones Varied
Get Device Firmware Version
Update Tags with RMS
Update Firmware with RMS
Disconnected